Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ceiling Fan Remote Control doesn't work after I changed the batteries
[ 4 Answers ]
I just changed the batteries in my Hampton Bay ceiling fan. Now the fan is running and won't respond to the remote control. The remote seems to be working properly. What do I need to do to get the fan and the remote to sync up once again?
Chevy truck alternator problems
[ 4 Answers ]
I have a 1985 winnebago motorhome. Chevy truck, 454 eng platform. The alternator seems to work OK but when you rev up the motor the voltage gage is pegged at 18 volts. I turn off the motor then restart and it works OK until I rev it up again, Same thing happens. I have replaced the alternator. ...
1982 dodge truck alternator not fully charging
[ 1 Answers ]
I have been working on my 1982 dodge d 150 truck with a 318 and my alternator is not completely charging my battery. It will run for a little bit but when I turn on the lights it dies with in 5 minutes. I replaced the alternator then took it back and had it checked, it was good. I noticed tha the...
1982 dodge truck alternator problems
[ 3 Answers ]
I have a 82 dodge d 150 with a 318 my truck was dying and was not charging so I changed the alternator and it worked until I turned on the headlights then it died I noticed that the belt was loose so I tried to tighten it and then it ran fine all day then that night I turned on the lights and it...
Dead batteries in RTH230B
[ 1 Answers ]
We are going through a set of batteries every week. We have a gas furnace and central air. THe thermostat has a red wire to the Rh terminal, a jumper to Rc, white wire to W, yellow wire to Y, and a brown wire to G. Everything works fine other than draining the batteries. View more questions Search
|