Ask Experts Questions for FREE Help !
Ask
    y22gregg's Avatar
    y22gregg Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Feb 14, 2010, 06:02 PM
    Can I insert beadboard behind existing baseboard heating
    I want to install beadboard in a room that has existing baseboard heating units. Is it possible to adjust/space these units away from the wall far enough to fit the beadboard in behind them (without having to do any plumbing work)?
    mtconc's Avatar
    mtconc Posts: 119, Reputation: 9
    Junior Member
    		  
    #2

    Feb 14, 2010, 06:21 PM

    You are asking about full thickness 3/4" lumber... or plywood/ paneling
    y22gregg's Avatar
    y22gregg Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Feb 14, 2010, 06:44 PM
    It's a paneling system. Definitely not 3/4" thick, but not exactly paneling either. Likely 3/8" think in 6 to 9" wide strips.
    mtconc's Avatar
    mtconc Posts: 119, Reputation: 9
    Junior Member
    		  
    #4

    Feb 15, 2010, 12:15 PM

    Copper pies or pex?
    y22gregg's Avatar
    y22gregg Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Feb 15, 2010, 01:14 PM
    Copper
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Specific task: Insert rows into existing table [ 9 Answers ]

Specific task. See Attachment. Thanks!

Fireplace gas insert (heating unit) [ 2 Answers ]

This unit is about 5 years old and the pilot light went out, I can light the pilot however it won't stay lit. While following the lighting instructions I can light the pilot and holding it in for about 1/2 minute the pilot will stay lit but when I beging to release the stem the pilot goes out? ...

Baseboard heating [ 1 Answers ]

I have baseboard heating and it it just not heating all the way it gets so far in the pipe but just doesn't reach the room where I have the heating system I tried to bleed it a couple of times first nothing came out second time a little water came out then the third time a little bit of air came...

Baseboard heating [ 5 Answers ]

I have electric baseboard heat. The heat concentrates more at going up the wall instead of into the room. I have tried heat deflectors, but the heat melted the plastic. Is something wrong with them or is there something I can use to deflect the heat into the room. We try to keep the temp down...

View more questions Search