Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wall pipe too high
[ 15 Answers ]
I am installing a new lavatory in the master bathroom. I think my plumber set the drain pipe too high up on the wall. I slide the J bend all the way up onto the tailpiece but I still have a 3 inch gap between the J bend and the wall tube. What is the best solution for this problem?
Need to value oil canvas found in wall
[ 8 Answers ]
A friend has found an oil painting rolled up inside a wall. He described it as about 24X16. It used to be framed. The signature reads A. Phalipp or Pholipp (or perhaps Philipp but probably not). It is a picture of a young boy around the turn of the century maybe earlier. He is a redhead with blue...
Removing pipe through wall
[ 1 Answers ]
Just connected to sewage. The pipe to the old septic system was capped but left in the basement wall. The plumber's recommendation was to leave the pipe rather than take the chance of water leaks where the pipe would be removed. It would seem to me that a properly performed patch in the cinder...
Bathroom sink wall pipe drain pipe
[ 2 Answers ]
My house was built in early 70's.. No plastic.. I'm putting in a new sink and had to remove the wall pipe that goes into the wall.. I needed a longer one. It seem where it goes in behind the wall into the plumbing there was some type of gasket as pieces of it fell out when I removed the pipe.. I...
Broken pipe in wall
[ 1 Answers ]
:'( Trying to fix clogged drains. While unscrewing pipe fitting from wall, pipe cracked. Lots of buildup in the grooves. Trying to replace the fitting and it won't fit due to grooves not being clean. What 's the best way to clean the grooves. Been "chipping" at it for 2 days... we are out both... View more questions Search
|