 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Luxaire troubleshooting
Our luxaire is a high efficiency model and frequently will shot off before the requested temperature is reached. We just had the "Initiator Motor" (power vent motor) replaced because it seized up. I thought the issue was related but it is not. The problem happens several times/day. If I shut the heat mode off on thermostat and then turn on in a few seconds, the furnace comes back on and sometimes will reach the set temp on the thermostat. When the motor was replaced the technician cleaned the flame sensor tip. Any ideas?
|
||||
Check out some similar questions!
Hello. I am hoping somecan can give some ideas for a fix. I just had a brand new Luxaire 95% + gas furnace installed in my home. Intermitantly I get the 4 red flashes error, the heat turns off and the blower stays on. Sometimes it corrects itself and fires up again while attempting to satisfy the...
Are luxaire furnice fires up than the gas shuts off and blows cold air,turnit off and on the switch on it might work right sometimes. Ireplaaced the ignighter aand it did not make any diff.
Within the last couple of days, the blower will not shut off. You can hear it shut off momentarily and within a second or two turn on again. I am able to shut the actual heat off using the thermostat, but that does not affect the blower. I can turn the entire unit off using the switch on the side...
I am in the third heating season with my Luxaire system. One of my units stopped blowing air and if I swith it to manual, it still does not initiate the blower. The burners fire up and burn for about a minute but the blower does not start and the burners shut off. What controls the blower...
Preasure switch stuck open how do you get it unstuck
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
