Ask Experts Questions for FREE Help !
Ask
    hector78's Avatar
    hector78 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 6, 2010, 04:21 PM
    Gas valve don't open in my fuenes what can I do?
    The gas valve don't open every thing works but gas doesn't go through
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Feb 6, 2010, 04:47 PM
    Check for voltage (usually 24 volts) at the gas valve when the furnace is in operation and the thermostat is calling for heat.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas valve won't open [ 2 Answers ]

My Lennox G 20 furnace starts up well but the gas valve doesn''t open. A repairman said there was voltage to the gas valve but insufficient to open it. He suggested the ignition module. As both of these parts are expensive and only one is faulty, I am wondering if this diagnosis sounds...

Pilot light stays lit, but the gas valve will not open [ 1 Answers ]

I have an old Thatcher furnace model 53170. The pilot light stays lit, but the gas valve will not open to ignite the burners. I have a constant 24v across the transformer terminals. When I check the terminals at the gas valve I experience an intermitant 24v signal about every 5 minutes. I can't...

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Carrier furnace gas valve won't open [ 8 Answers ]

Hello, My carrier furnace is on the fritz. I am receiving a 34 code which states"ignition proving failure" The blower fan starts and the hot surface ignitor lights but no gas flows. I replaced the ignitor with a new one-no help. The flame sensor is clean.When I check voltage at the gas valve...


View more questions Search