Ask Experts Questions for FREE Help !
Ask
    UTBoomer's Avatar
    UTBoomer Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 2, 2010, 10:16 AM
    Bryant plus 90 troubleshooting
    I have a 23 year old "Bryant Plus 90" furnace. Until my house reaches the thermostat setting the burners remain on and the blower cycles on and off in 7 to 10 minute cycles. Should the burners remain on without the blower being on?
    UTBoomer's Avatar
    UTBoomer Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Feb 2, 2010, 10:21 AM
    Bryant plus 90 troubleshooting
    I have a 23 yr old "Bryant PLUS 90 furnace. Until the temp reaches thermostat setting the burners remain on while the blower goes through 7 to 10 minute on and off cycles. Is this normal?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Luxaire troubleshooting [ 9 Answers ]

Hello. I am hoping somecan can give some ideas for a fix. I just had a brand new Luxaire 95% + gas furnace installed in my home. Intermitantly I get the 4 red flashes error, the heat turns off and the blower stays on. Sometimes it corrects itself and fires up again while attempting to satisfy the...

Hitachi TV troubleshooting [ 10 Answers ]

Hi! I have hitachi TV and using hitachi remote control which is for different model but it works fine.I have just pressed button EXP (expend )on remote and it put my TV on sleep mode type of thing.When I on my TV it comes up just for few seconds and then shuts off.Its not swhitching on.Please help

Luxaire troubleshooting [ 0 Answers ]

Preasure switch stuck open how do you get it unstuck

Troubleshooting. [ 2 Answers ]

I'm trying to trouble shoot an older computer I inherited. I am completely new to PCs. At any rate it has two problems that are possibly relateed. 1. The image the monitor (I have tried 2 different working monitors) has a bunch of red (sometimes grey) vertical lines across the screen which...

Second HD troubleshooting [ 1 Answers ]

Ok, here's the skinny... Intstalled my girlfriend's HD (Maxtor DiamondMax Plus 9 80GB ATA/133 HDD) onto my computer as a 2nd HD(slave). All jumpers are set correctly, all cables are correct (not the 1st time I've done this). Everything works fine, it's detected and I do have access to it. ...

View more questions Search