Ask Experts Questions for FREE Help !
Ask
    Hahsbaum's Avatar
    Hahsbaum Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 30, 2010, 01:22 PM
    Trane Furnace, code 8
    What is the problem with a xv90, code 8
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #2

    Jan 30, 2010, 06:23 PM

    Low flame sense. May need the burners and flame sensor cleaned.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane furnace troubleshooting - XV90 error code? [ 4 Answers ]

My XV90 upflow furnace gives a 9 red flash code when it starts up. My installers guide says it is an "Open Inducer Limit switcch". The furnace works OK, should I be worried about this?

Do trane gas Furnace have belt and how to fix trane gas Furnace [ 1 Answers ]

I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(

Trane Furnace error code = 2 flashes, what does system lockout mean? [ 1 Answers ]

I have a Trane forced air furnace which recently has had periods when it blows unheated air. When I looked at the furnace during these periods it shows 2 flashes, which according to the instruction manual is an error code which means: System lockout, retries or recycles exceeded. I don't...

Trane XE80 furnace occasionally produces no heat, error code 4 [ 3 Answers ]

Hello, I have a Trane XE80, model number TDD080C936E0. A few weeks ago, it started blowing only cold air with error code 4 - high temperature limit open. If I shut it down, and start it up again in about an hour or so, sometimes it comes back on, sometimes it doesn't (produce cold air only). ...


View more questions Search