 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
What fuses do I need to run a 96 4.3 vortec
I put a newer used 4.3L vortec vin w in a 96 GMC sierra and it's the same engine and all the lights and electrical stuff work. The check engine light and air bag light is on. It turns over but it won't start. I thought it might need more gas but it wasn't that and I put dry gas and I here the fuel pump turn on and off. I thought it might be fuses or the distributor but I don't know.
|
||||
|
||||
|
Test all under dash and under hood fuses with a test light or multimeter: https://www.askmehelpdesk.com/cars-t...tml#post252145 |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Any 1 know how to remove the trans. Pan to change the filter and leaking gasket? It has a cross member going from 1 side of the frame to the tramsmission, the to the other side of the frame , and if it was moved like 1 inch I could get the pan out, but not sure if that's safe Any 1 did...
What is the diffrence between the vortec 350 and the chevy 350 can you put a vortec in a older truck that had a 350tbi (1994)
I am wiring a bedroom ceiling fan and just needed someone to help me figure out part of the wiring I'm not sure about. The goal is to have a 2 gang switch control the light and the fan separately. The switch is at the beginning of the run, then the ceiling fan, and then I also have an "always...
I have around 800 miles on my new vortec 350 motor so when I go to power brake and smoke the tires I here the lifters knock or a gas ping noise what could cause this.
Hello, I am intending to replace some wire that runs for 200 feet, from my meter to my house.I live on an island, so the run is quite long ! At either end are breaker boxes with 100 amp fuses in each.Never had any trouble/ fuse blows etc. The old wire (each of the 3 strands) are a little...
View more questions Search
|
