How to wire up a house thermostat 6 wire to a 5 wire

rg6668 Posts: 2, Reputation: 1

New Member

Jan 28, 2010, 06:03 PM

How to wire up a house thermostat 6 wire to a 5 wire

I have a old honeywell thermostat that 6 wires no one make it no more I got a new 5 wire thermostat honywell how would I hook it up

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Jan 28, 2010, 06:17 PM

Post EXACT model number of both thermostats.

wmproop Posts: 3,749, Reputation: 91

Ultra Member

Jan 28, 2010, 07:14 PM

Read the instruction manuel

Add your answer here.

Check out some similar questions!

Misuse of ground wire as neutral return wire in old house [ 5 Answers ]

Here a problem where the "obvious" solution scares me, need some advice on how to best proceed. My home (built 1920 with knob and tube type wiring) has been upgraded over the years by prior owners, but in many place still has active current in the old wires, in other places it is spliced into a...

Trane thermostat 5 wire versus 3 wire [ 2 Answers ]

Hi, Maybe this is discussed in here elsewhere, but I didn't find it. I want to replace a Trane TCONT802AS32DAA 5 wire thermostat with a Trane TCONT900AC43UAA 3 wire. Is this possible? The current wiring is Red wire to RC with a jumper to R White wire to W1 Yellow wire to Y Green wire to...

Black wire red wire and white wire spliced to 10/3 on a 220 circuit [ 25 Answers ]

I have installed a disconnect between my dryer receptable and a tanning bed. I want to splice the 10/3 box wire to the existing 220 wiring at the dryer. Dryer= red, black, white and bare ground wires 10/3 wire= black, white, and bare ground How do I splice these to allow the disconnect box to...

How to wire 3 wire 2 zone cooling only to Honeywell thermostat [ 10 Answers ]

I currently have two zones for cooling only and the thermostat wires are red, blue and white. The red is labeled Rc which is easy, the white is labeled W Heat (this doesn't make sense to me) and the blue is labeled cool? What I think I need to do is connect the red to the Rc on the thermostat,...

Wiring a 2 wire thermostat to a 4 wire system [ 1 Answers ]

I have a gas furnace equipped with central air.The compressor is shot in the AC unit,and I needed to replace the thermostat so I bought a heating only thermostat.I have the blower and the w wires together on the w terminal designation and the rh on the r terminal designation, and I have the y wire...