Ask Experts Questions for FREE Help !
Ask
    Hughes5544's Avatar
    Hughes5544 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2010, 08:47 PM
    Bryant gas pack not staying lit
    Bryant gas pack model # 583ANN030060AAHD one of the two burners ignites and then kicks off, will not stay lit. No codes showing and NO heat!!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 28, 2010, 07:36 AM
    Clean both burners and especially the flame jumper area. If equipped with a flame sensor clean it with fine sandpaper or steel wool.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane xv80 not staying lit [ 4 Answers ]

My furnace is 5 years. Every time it calls for heat it fires up just fine but then after 3 sec. the gas turns off, it repeats this cycle until it locks out the system. I have reset the system, checked all the wiring for loose connections but cannot get it to run. Please help me.

Dryer not staying lit [ 0 Answers ]

Kenmore elite gas dryer only stays lit for 10 seconds, goes out for 1 to 2 minutes then does this again

Furnace pilot not staying lit [ 6 Answers ]

The older sears furnace here, has a pilot light that lights But goes out, as soon as the pressure on the pilot button is released. Now two times it did stay lit and then soon went out. If the orifice needs cleaning are there diagrams of where that is or how to do that? Thanks

Again w/ the pilot light not staying lit [ 4 Answers ]

Today I cleaned out the space beneath the water heater flue connection in the wall, supposedly this area is for that purpose; to clean out the flue. You would not believe what the last tenant jammed in there... 2 bed sheets! OK, well I cleaned that out, plus a half of a bucket of dirt. We replaced...

View more questions Search