Ask Experts Questions for FREE Help !
Ask
    cquinones's Avatar
    cquinones Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2010, 02:07 PM
    Weather maker 8000 furnace
    I changed the ignitor and the thermostat on my weather maker 8000, the fan runs good but there is no flame coming out at all, neither the ignitor will turn red. What else should I check?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 27, 2010, 02:53 PM
    Is there power going to the igniter,, check at the circuit board
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #3

    Jan 27, 2010, 08:30 PM

    When you say that the fan is running I assume that you mean the exhaust assist fan. If it is running and the ignitor not getting red you ned to check for power to the ignitor, You can do this by unpluging the connector that is about eigh to ten inches from the ignitor and use a volt meter in the two terminals that you npluged the ignitor from, now turn up the thermostat and see if you have power there, if you do that means the ignitor is bad. You said you changed the ignitor but these things are very fraigle and could have gooten broke. Also do not touch the gray part of the ignitor with your fingers, the oil will make the material burn into.
    weathermaker 8000's Avatar
    weathermaker 8000 Posts: 5, Reputation: 1
    New Member
    		  
    #4

    Mar 3, 2010, 09:42 PM
    Quote Originally Posted by letmetellu View Post
    When you say that the fan is running I assume that you mean the exhaust assist fan. If it is running and the ignitor not getting red you ned to check for power to the ignitor, You can do this by unpluging the connector that is about eigh to ten inches from the ignitor and use a volt meter in the two terminals that you npluged the ignitor from, now turn up the thermostat and see if you have power there, if you do that means the ignitor is bad. You said you changed the ignitor but these things are very fraigle and could have gooten borke. Also do not touch the gray part of the ignitor with your fingers, the oil will make the material burn into.
    I did that still will not ignite the fan kicks off after a few minutes
    weathermaker 8000's Avatar
    weathermaker 8000 Posts: 5, Reputation: 1
    New Member
    		  
    #5

    Mar 3, 2010, 09:44 PM

    The fan kicks off after a few minutes
    Lawless84blue's Avatar
    Lawless84blue Posts: 1, Reputation: 1
    New Member
    		  
    #6

    Aug 28, 2011, 11:52 AM
    Does any body have a mainboard to the weathermaker for cheap
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier weather maker 8000 [ 6 Answers ]

Hi everyone. I am new to this forum and would like your help. I have a Carrier Weather Maker 8000 and I am having problems with it. Its keeps shutting off before it reaches the desired temperature . I made a couple of clips that I hoped would explain the problem better. The Start:...

Weather maker 8000 [ 2 Answers ]

If you install a weather maker 8000 upsidedown will it affect anything, or is it happy under any application?

Carrier Weather Maker 8000 [ 2 Answers ]

We just moved into a home and have a Carrier Weathermaker 8000 gas furnace. Most of the time the furnace works well but at times it comes on many times in a row and in short intervals?? It ignites for only 1 minute at a time but at least 20 times in a row, this doesn't seem a regular operation. ...

Carrier weather maker 8000 [ 5 Answers ]

Model # 58TUA06008 has had the main board replaced but it keeps shuting off and then will restart after four hours or if I shut the power off and turn it back on. Is this an issue with the heat sensors or something else. I known the main board has been recalled is there any other issues. Thanks G

Weather maker 8000 R-W [ 1 Answers ]

We have a weather maker 8000. And we have gotten a code 12 from the L.E.D light. The code means R-W closed. My question is what is the R-W and where is it located on the Weather Maker 8000?:confused:

View more questions Search