Ask Experts Questions for FREE Help !
Ask
    mcarosiello's Avatar
    mcarosiello Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 24, 2010, 05:17 PM
    Warped Aluminum door frame
    My 6ft aluminum door frame is warped and sticks. Is there anything I can do?

    Marjie
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #2

    Jan 25, 2010, 02:44 AM

    If the header of frame is lower in middle of door unit, can be raised with screws that secure header to wood framing.

    Or u can adjust the height of door by screws located at bottom of door at each end. These screws are recessed and can be adjusted with a phillips driver.

    Good luck

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Entry door aluminum threshold [ 12 Answers ]

I'm replacing a aluminum threshold. How do I remove the old one? There are no screws and the threshold ends run under the door frame. Do I need to remove the door casing?

Broken screws for adjustable wooden threshold in aluminum frame [ 2 Answers ]

I have an exterior door that has a wooden threshold inserted in an aluminum frame. The wooden insert is adjustable with four aluminum screws. The screws rusted to a steel nut that was in lower aluminum frame. All four screws are broke. The woodedn threshold (oak) is in good shape but I need...

Removing Steel Door Frame [ 4 Answers ]

I have to replace a steel door and steel frame. I see that there are three large flat top screws on each side of the frame. I take it, these hold the frame to the poured concrete wall. The problem is that these screws are not moving at all. The door in question is badly rusted as is the frame and I...

Warped sliding glass door frame causes door to stick. [ 5 Answers ]

The center of our 8 foot sliding glass door bends out about 3/8 inch more than the two ends causing the door to wedge against trim that keeps the door from falling out when the door is closed making it difficult to open the door. How do I get the center of the door frame into place so the door...

Door Frame on Concrete Block [ 4 Answers ]

I have a 3 year old house and my walk-in door to my garage had, yes had a Pine 2X8 non-treated rough opening on concrete block. Rough opening and wood door frame has rotted. I have obtained a Vinyl door frame kit and I am wondering the correct procedure to install the new Treated Wood rough opening...

View more questions Search