Ask Experts Questions for FREE Help !
Ask
    fensen's Avatar
    fensen Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 23, 2010, 12:53 PM
    Honeywell rlv430 thermostat
    I hooked up the unit (honeywell rlv430 thermostat) (it had been in storage, in original packaging for 4 years) and get nothing appears after the power is turned back on. The wires are live (I checked that), is there someway to determine if the unit itself is bad or to reset it so it might work?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 23, 2010, 01:48 PM
    Here is a copy of your manual for that item.

    Check wiring
    Check for proper application and voltage.

    http://customer.honeywell.com/techli.../69-1874ES.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell RLV430 thermostat leaving burn marks on wall [ 3 Answers ]

I have two RLV430 thermostats, one in each of two bathrooms, running electric baseboard heat. Both have one inch to two inches of black marks on the walls above the right side, control pad; almost as if something had or is slowly burniing. Suggestions?

No Display on the Honeywell RLV430 [ 2 Answers ]

We are trying to install a RLV430 to replace an older model of a Honeywell thermostat and there is no display on the LED. We even purchased another thermostat (same model) because we thought the first was defective but we're experiencing the same issue on that one. The wall has a black and...

RLV430 Honeywell Thermostat [ 3 Answers ]

I am trying to replace my old manual thermostat for a programmable Honeywell RLV 430. I have two base board heaters to hook up to the thermostat but not sure what wires to match up to.

Honeywell RLV430 Forced Air Thermostat Wiring [ 2 Answers ]

I have a question regarding a Honeywell Thermostat installation. The model is a Honeywell RLV430 and is connected to a forced air heater system with two heater units. I installed the previous model (about 1-yr ago) after I had removed the contractor's Cadet dial thermostat and wired it the...

Thermostat Honeywell RLV430 [ 1 Answers ]

The Manual says that this thermostat can only be used with a resistive load over 2A . Is there any way this ca be change to use it for a furnace heating system ? Not resistive ? Thanks

View more questions Search