Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have two toilets in my house. Recently both toilets have stopped fininshing flush
[ 1 Answers ]
I have two toilets in my house and recently both have stopped flushing completely. Flush starts fine, but at end of flush toilets power seems to stall out. This system is on city sewer service, and until past week or so both toilets were fine. Now I am forced to flush toilets up to three times to...
Double trap OK? Rough in piping + tub trap
[ 10 Answers ]
The way the 2" rough in went we ended up with a trap of sorts then a pipe to where the tub trap will be. Not completed yet. Just wondering if a tub trap and a trap made with the rough in piping will cause some sort of problem. The rough in trap was made off a 4x4x2 wye. Would that be adequate...
Basement Bath P-Trap Install Details
[ 1 Answers ]
I am preparing to install a bath tub in a new basement bath. The groundwork is done, dirt's back in the hole and my next step is to re-pour the concrete. I know I need to leave a box around the tub drain and vent connections for hook-up later and have a few questions on the details. 1. How...
Replace P-trap with drum trap--good idea?
[ 3 Answers ]
Hi, I have a large crack in a cast iron waste line. The line at that point serves just the kitchen sink and is vented to the roof. The first plumber I called wants to disconnect the P-trap, install a drum trap, drill through the cabinet and floor, and connect to the waste line down below the crack....
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all... View more questions Search
|