Ask Experts Questions for FREE Help !
Ask
    Jbrebeuf's Avatar
    Jbrebeuf Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 14, 2010, 12:38 PM
    Trane xl80 controller red light always on
    Trane XL80 flame sensor has been cleaned. The gas will light up and heat for 10 minutes sometimes longer but later the white rodgers controller unit led will change from flashing red light to constant red light. Then no more flame. Thermostat still is on and has not reached the chosen temperature setting.

    When do you know for sure that the controller board is really bad and needs replacing when it seems to work after I unplug the furnace for a few hours?
    tony58's Avatar
    tony58 Posts: 1, Reputation: 1
    New Member
     
    #2

    Nov 7, 2010, 07:03 AM
    If blower not working hit the reset then shut down heater for 2 hours then start back up this should sovle this problem

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane XB90 Gas Furnace -Red Flashing Light [ 6 Answers ]

My Trane XB90 Gas furnace has a red flashing led light. Is this a problem? What does it mean? Thanks in advance...

Trane XL80 [ 1 Answers ]

Hello My furnace blows cold air at the beginning and at the end of each cycle, is this normal? Also the furnace seems to start every 15 minutes regardless of whether the temp. drops or not. I was watching the thermostat last night and the temp. would not drop on the thermostat screen but the...

Trane xl90 gas furnace red light [ 1 Answers ]

I have trane xl90 gas upflow furnace red light blinking on circuit board no legend any where anybody know where to get information

Trane xl80 [ 5 Answers ]

The heater will run for awhile and then I will get the @ Flashes code! External Lockout (Retries or Recycles Exceeded) What will solve this problem? Dorsia


View more questions Search