 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Low water pressure in kitchen only
Hello-
We have been experiencing decreasingly low water pressure in our house. The city installed a new meter which improved everything but the kitchen water pressure. I have an American Standard Reliant+ Pull Out faucet and a Maytag Jet Clean dishwasher. I have dissembled the faucet to check the cartridge for clogs (no aerator screen on this model) but everything looks fine. Today is the worst it has been and I'm afraid there might be a leak or bad pipes. The water pressure on the outside hose closest to the meter and in the backyard is fine, along with the rest of the house. Any advice would be greatly appreciated. |
||||
|
||||
|
Hi Commandrea:
After reading your description, the next thing I would check are the shutoffs under the sink. Here, shut off the valves going to the faucet and disconnect the water supplies to the faucet. Next, direct the risers into a bucket and turn the water back on to see what the water flow looks like. If the pressure is powerful then the problem is at the faucet, below the cartridge. If the pressure is low then the issue could be at the shutoffs under the sink.. or even further back... ;) If you are lucky, could be that the shutoffs themselves are not opened fully! I'll cross my fingers that it is that easy. Let me know what happens... MARK |
||||
|
||||
|
Hi Mark- Thanks for your reply. Luckily I didn't have to disconnect the water supplies but, guess what! I fixed it! I first checked the cartridge which seemed fine. Then I put everything back and disconnected the faucet head from the hose and turned it on. The FULL BLAST of water coming out of the hose end was a great sign, so that narrowed it down to the faucet with built-in 'shower' head. I attempted to get some vinegar inside of the faucet head, but didn't have the patience to wait and there is no way to directly access the innards of this piece so I pushed the valve open (inside where the hose attaches) with a little hex screwdriver and pressed the faucet opening firmly over the hose and turned the water on, spraying water through the head and out the back end. The force of the water from the hose pushed out the sediment (I didn't see anything come out, but it must have) and when I reattached the faucet- voilą!- my water pressure was back to normal! WHEW! What a great feeling :) Andrea |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
We have a Proce Pfister 'Classic Series' kitchen faucet and the water pressure is very low. We have replaced several of its cartridges and there has been no appreciable change in the water pressure. What else can we check?
We are having problems with the water pressure at the kitchen sink. All of the other sinks and tubs are fine. Just the kitchen sink. Please help!
Hi, I have low water pressure in the kitceh, that means the sink and the water line for the fridge. The water pipe that feeds the kitchen is the same as the powder room sink and the backyard line. I have a lot of pressure at the end points (powder room sink and the backyard) but not in the kitchen...
The water pressure in my kitchen is LOW!! The problem started about 2 months ago when my dishwasher was not getting any water to it. The machine would run, but no water was coming in. Since then, the water pressure in the sink beside it has continued to diminish to the point that is is so low now...
Single floor 1 bathroom Florida home, water pressure is fine everywhere except kitchen. Replaced faucet, cleaned screens and filters to no avail. Suggestions?
View more questions Search
|
