P trap dimension specifications

khattak Posts: 1, Reputation: 1

New Member

Jan 13, 2010, 07:39 AM

I need 2"p-trap dimension specifications

I need p-trap dimension specification

speedball1 Posts: 29,301, Reputation: 1939

Eternal Plumber

Jan 13, 2010, 07:55 AM

What fixtures will the traps service and what material should they be?
Let me know, Tom

Add your answer here.

Check out some similar questions!

Difference between p-trap and s-trap because of any plmbing reasons [ 2 Answers ]

Ia there any plukmbing reason to use a P-trap than a S-trap?? If so, what is it?

Double trap OK? Rough in piping + tub trap [ 10 Answers ]

The way the 2" rough in went we ended up with a trap of sorts then a pipe to where the tub trap will be. Not completed yet. Just wondering if a tub trap and a trap made with the rough in piping will cause some sort of problem. The rough in trap was made off a 4x4x2 wye. Would that be adequate...

Changing out PVC P-trap to decorative P-trap [ 10 Answers ]

My husband and I are in the process of changing out a vanity in our guest bathroom and I have a few questions. We removed the old vanity and had to cut the old p-trap off with a hack saw. We are replacing with an open vanity so now the pipes will be exposed. I want to tile half way up the wall,...

Replace P-trap with drum trap--good idea? [ 3 Answers ]

Hi, I have a large crack in a cast iron waste line. The line at that point serves just the kitchen sink and is vented to the roof. The first plumber I called wants to disconnect the P-trap, install a drum trap, drill through the cabinet and floor, and connect to the waste line down below the crack....

P-trap GAP - p-trap too low to meet sink drain extension [ 13 Answers ]

I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all...