| 
 
 
 
 
  Not your question?
  Ask your question
  View similar questions
   
 Add your answer here.Check out some similar questions!
Is it safe to replacing a lighter gauge wire with a heavier gauge
 [ 11 Answers ]
 Hi all, One of my baseboard heater (240v)'s wire was broken can I replace it with a heavier gauge wire? Also can different gauge ground wires (copper wire) be connected with a wire-nut? IS THIS SAFE TO DO? OR Will this create a fire hazard? 
Track lights: low voltage vs line voltage.comsume the same electricity in the end?
 [ 11 Answers ]
 Hi! I just installed a section of track light in my living room just to see what it would look like and so far I'm not convinced... you see, I had a regular celing lamp with a 75w incandescent bulb and the room was very well lit... now with the track light I find that I need 3 fixtures with halogen... 
Can I attach a 14 gauge light into a 12 gauge circuit
 [ 3 Answers ]
 Is it acceptable to attach a 14 gauge light in a 12 gauge 20 amp circuit? I am finishing my basement and using 12 gauge wire throughout. When I bought my light fixtures, they are wire with 14 gauge wire. Is it safe to use these or do I need to get different light fixtures? 
Connecting 12 gauge and 14 gauge wire
 [ 4 Answers ]
 Is it ever acceptable to attach 14 gauge to 12 gauge wire? I have a remodel situation where I have a 20 amp/12 gauge wired circuit powering outlets only. I want to tap off the end-of-run outlet to power an electric-venting skylight. The skylight comes with 14/2 wire. Can I tap off the 20 amp... 
Connecting 14 gauge wire and 12 gauge wires in the same blue box.
 [ 2 Answers ]
 I am wiring my basement. All the outlets are running off 2 independent 20 amp circuit breakers connected to each other by 12/2 wire. I wanted to run some stubs off my 12/2 outlets. All each stub would do is run to a small light (max 180 watts) and of course a light switch. Since I ran out... View more questions Search 
 |