Ask Experts Questions for FREE Help !
Ask
    lyndagale's Avatar
    lyndagale Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 6, 2010, 06:53 PM
    My armstrong ultra sx 80 furnace will not ignite. I have replaced the dirty filter,
    My armstrong ultra sx 80 furnace will not ignite. I have replaced the dirty filter, but the fan stay on all the time, without igniting the pilot. I have already checked out the rubber tube connected to the pressure switch/ combustion area. There is no rust or clog, and when I blow in the tube I can hear the valve diaphragm moving. Is there a sensor that might need to be cleaned? The unit is only 7 yrs old and has never before been a problem.
    builderbob1's Avatar
    builderbob1 Posts: 41, Reputation: 2
    Junior Member
    		  
    #2

    Jan 8, 2010, 12:25 AM

    I need more information.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Jan 8, 2010, 04:21 AM
    Look on the back side of the furnace blower motor acces door for a wiring diagram. Look on the diagram for the high limit safety then follow the wires on the diagram to the control. There should be a very small reset button on the control. Push to reset and try to operate the furnace.

    NOTE make sure to turn off the power before you reset control for your safety.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Armstrong Ultra SX 80 furnace won't stay on [ 16 Answers ]

We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...

Armstrong ultra sx-80 furnace problems [ 4 Answers ]

I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...

Armstrong Ultra V Tech 80 furnace troubleshooting [ 0 Answers ]

My armstrong Ultra V Tech 80 furnace suddenly doesn't want to ignite. Please bear with me as I don't know a whole lot about furnaces. I can hear and see the gas come on, but it does not ignite. I can hear a clicking noise I assume is the ignitor trying to engage, but the furnace doesn't start. It...

Armstrong Ultra V Tech 80 Filter change [ 3 Answers ]

Where is the filter located for an Armstrong Ultra V Tech 80 furnace? How often should it be changed? This is a forced hot air system. Also has central air. Can they be purchased locally ie: Home Depot or Lowe's? Tha nk you.

Armstrong ultra sx 80 furnace no pilot light [ 3 Answers ]

We've had a problem the last 2 winters with our furnace, always fixed but last night the furnace stopped working. We checked and there was no pilot light. Actually in this model we don't even know where we would light it. Someone told me it might be the thermo couple but I am in need of another...

View more questions Search