Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cast Iron piping under concrete filled with dirt
[ 5 Answers ]
Our house resides on a ranch, a 4 inch slab of concrete. The full bathroom is located directly straight from the access area on our front lawn (sewer). We had a problem with water backing up there, so we had roto rooter snake it, which relieved the problem. But we were still experiencing bubbles...
DWV Removing Corroded Brass from Cast piping
[ 10 Answers ]
Hello I'm new to this so I apologize if I do anything that I'm not supposed to. I ran across this site while surfing the internet and thought there might be a possibility that the masses might be able to help me out with a little road block. I am in the process of replacing the kitchen sink drain...
Removing cast iron pipe
[ 1 Answers ]
I have a section of cast iron pipe (it is about 18 inches in length) in the crawl space under my house that has holes rusted in each end that goes in to the joint (bell? the section at the end that is larger than the pipe, where the pipe goes in), I am not sure about the size but I think it is 4...
Removing Brass pipe from Cast Iron
[ 8 Answers ]
http://www.msnusers.com/dddm86ru89coki506bhl3iuih3/Documents/Pictures/May162007drain%20004%2Ejpg Hi, I'm trying to remove a brass pipe from a cast iron floor drain in the basement. The pipe is part of a backwater floater ball unit. I removed the brass cleanout plug with a crescent wrench...
Removing cast iron / lead joints
[ 4 Answers ]
Hi; I have a vertical 2 inch cast iron vent pipe that I need to remove to install a medicine cabinet. I have cut it in one spot with a sawzall, but there is also a joint in it where I would like to separate it. The joint appears to be poured with lead. If I heat it with a propane torch to get it... View more questions Search
|