Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Power vent hot water tank cutting out
[ 2 Answers ]
After usage of hot water, blower comes on, ignitor ignites but no gas released to heat hot water. Why? This is a Rheem Power Vent.
Cutting into clay sewer piping
[ 1 Answers ]
Hello, We are experiencing root problems in our main drain line. I dug up the stretch of pipe that has the worst root intrusion so I can install a 2 way clean-out in order to snake both directions if we have any further problems. Right now my run to the street is like 150' so I don't want to dig...
Danger of methane gas explosion while cutting metal vent pipe
[ 3 Answers ]
I need to cut into a metal vent pipe in order to insert a tee and create a drain for a washing machine hoop-up. I am wondering if there is a danger in using a reciprocating saw (sawsall) to cut the pipe, a danger as in "explosion"! Are there alternatives to cutting the pip in a very limited space...
Freezing/icing at outside vent
[ 8 Answers ]
I have a plus 90 bryant furnace, vented out on north side of home, installed about 4 or 5 years old, when temp gets down around zero and some wind, usually, the vent will ice up and furnace will not come on? When I take vent cover in and thaw the ice off it, then furnace will come on?
Cutting a Cast Iron Drain / Vent Pipe
[ 2 Answers ]
I have a 4 inch Cast Iron Drain pipe that is in the wall and runs into the floor in the basement. It has 2 toilets and a sink and shower that drain into it. I need to replace the pipe with PVC. It is from just above the basement floor (built into a side wall) and runs all the way through the... View more questions Search
|