 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Removing mixet shower valve stem
Hi,
The Mixet valve in my shower stall needs replacement since turning the temperature control handle is very difficult. The valve stem will not pull out using max force with channel pliers (padded), I can turn the brass screw adjustor and out comes the front part but that leaves the rear portion of the stem in the pipe. I'm quite sure it is a Mixet MS5AT-C 4 1/2" valve cartridge stem model, it says Mixet on the valve. I'm a long-time DIYer but this one has me stumped. Question: How do I remove the entire valve stem? Is there a puller for this, I've looked online but couldn't find any for this particular problem. Thanks, Steve |
||||
Check out some similar questions!
Hello, I replaced the mixet 4 1/2" stem valve ,Its not wanting to work properly and in the instructions it says the "red dot" goes "up".. The replacement kit I got from home depot didn't have a red dot to be found or a small chennel in the brass. Any ideas on how to go about making sure the stem is...
Thanks for all the help. I did look into the pipe and there does appear to be a seat, but it is in poor condition. My seat wrench doesn't seem to work. Would W-D 40 help? :confused:
Model # A11.18.1M-Moen Do I need a special tool to remove it, to replace worn o rings?
Hello, I'm trying to replace the hot water and cold water shower stem to repair a leaky shower. I'm, however, learning it could be the diverter causing the leak. I don't care at this point; my goal is simply to remove the two stems (for hot and cold water) and replace them. The home is...
Hello,I will like to know can a tub valve stem get restricted with sediment and block Water flow till you get hardly nothing or just a stream?It has been leaking for Quite a while now and has gotten worser.I already have an existing sediment Build up from galvanized pipes.I been tapping the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
