Ask Experts Questions for FREE Help !
Ask
    jackie1968's Avatar
    jackie1968 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 4, 2010, 08:54 AM
    Corporate Office Goodman Furnace
    I have purchased a Goodman Gas-Fired Warm Air Furnace 11-08-04, I have had to replace the pressure switch two time's and at the present the Induced Draft Blower. I feel this should not be happening when the unit is only five years old, whatever happen to long lasting craftmanship? I am not aware of noises a Furnace might make if it is running wrong! The blower was bad when it was in warranty but I was not aware, it just expired 11-08-09!

    I feel something should be done about this! I am a very upset consumer! I want to write a letter to the Corporate Office and I can not find the addresses!

    Sincerely,
    Jacqueline Howell
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 4, 2010, 09:25 AM
    Where did you purchase the furnace? Who did the install?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Goodman furnace [ 3 Answers ]

Just bought it and installed furnace yesterday It lites and runs about 1 min,than the flame goes out and the plenum only gets luke warm. It blows cool air Thanks.

Goodman furnace [ 1 Answers ]

I have a new goodman furnace that only ignites and runs for a few seconds and then starts all over again and the blower runs constantly with the induction fan shutting on and off. Is this a limit switch making it do this?

Goodman furnace [ 1 Answers ]

Furnace flame will stay on for 5 seconds and shut off. Led light on circuit board flashes once after it completes cycle. 1 flash indicates the following possible problems: Gas flow... Gas pressure... flame sensor... as a result, everything seems to be working normal. However, I did replace the...

View more questions Search