Ask Experts Questions for FREE Help !
Ask
    Texasyankee32's Avatar
    Texasyankee32 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 30, 2009, 12:16 PM
    Question on hanging door alignment
    I have replaced 3 interior doors ( holow) with new MDF. I reinforced the jambs due to the weight on the door. That looka like iot is working. When I close the doors the last 6 inches feels constrained.. kinda like the hinges are closed but the door isn't just yet. At this time I can also see the Jambs move. I'm not sure how to fix this?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Dec 30, 2009, 05:58 PM

    Check that the hinges are flush with the surface of the door and the jam. Not recessed in the mortises.
    Check that the door is not rubbing against the door stop material on the hinge side. This is the most likely problem.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hanging a new interior door. [ 4 Answers ]

I am going to hang a new interior door. The old door was used to router out the hinge and handset placement. Here is the question. The new hinges are 3 inches long with a 1/4 inch radius. The old hinges are 3 inches with a 5/8 inch radius. Can I use the new hinge with the 1/4 inch radius? (the new...

Margin alignment [ 4 Answers ]

I can't seem to get my margin back after I draged it way to the top, I tried everything I can to get it back, reinstalling, reparing but it doesn't seem to help. Does someone know of a rest for Microsoft word 2007? http://img461.imageshack.us/img461/1278/untitledct5.jpg

Tricky Door Trim Question [ 2 Answers ]

I need to trim around a door in my basement. Because the door is under where I boxed in around duct work, there isn't enough room to trim around the top. Any suggestions?? Scott


View more questions Search