Ask Experts Questions for FREE Help !
Ask
    segovia58's Avatar
    segovia58 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 26, 2009, 09:31 AM
    Symmons temptrol leaking
    This is a symmons-temptrol. Leaking only at the tub spout. I don't know the model number but it is able to divert to either shower or tub. The tub spout leaks. What internal part should be replaced. I have a schematic listing parts T1 all the way to T55-c.
    The parts are further grouped in several sections. For example, T4 is actually a grouping of T1, T2, and T3. However, none of the parts is actually given a name.
    Any advice would certainly be appreciated. Thanks in advance!

Check out some similar questions!

Symmons - Temptrol Diverter [ 22 Answers ]

I have the above diverter in my bathroom. Recently it started to leak from the diverter handle that changes the use from tub to shower. I purchased the Symmons TA-25A Iverter Spindle to replace old. My problem is that I do not know how to remove the old spindle. Can anyone help me with my problem?

Symmons '76 Temptrol Model A [ 19 Answers ]

Hello, I purchased a TA-10 to replace the spindle in my Symmons '76 Temptrol Model A. After removing the original spindle I notice that the replacement part is different. Namely, there is no thread on the largest circumference part on the replacement part whereas the original has a thread....

Symmons Temptrol tub and bath faucet leaking [ 2 Answers ]

I have a Symmons Temptrol tub and bath faucet which is leaking at the handle. It is 20 years old and I suspect that the cartridge needs replacing. Do I remove the handle first and then the plate which is held by two screws? Where is the cartridge located? Is there some literature that will...

Symmons temptrol - no water [ 2 Answers ]

I'm getting nothing but a dribble on hot and cold, tub or shower settings. Was fine until today. Any way to tell if it is the valve or seat? There's nothing else to replace, right? Thanks

SYMMONS Temptrol leaking from diverter [ 1 Answers ]

Symmons sent the replacement seats and tools to repair a leak from the diverter hole that happens only when water is turned on. I replaced the seats, tightening by hand stopping short of cranking them. (I didn't use a torque wrench). Three times I removed them and adjusted them, but the...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.