Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bathroom plumbing leaks
[ 1 Answers ]
I installed two sinks where I previously had one. I piped them both through their own p-trap and then into a T joint and into the wall. I have a leak on both drains here the p-trap comes up and connects to the pipe that goes to the T-Joint. The piece that is leaking has a flange molded into the...
Hunter Bathroom Fan/Light question (older house)
[ 6 Answers ]
I just bought a new fan/light for my master bathroom, and was attempting to install it when I ran into a snag... The wiring described in the manual is black/white wires in the ceiling to black/white wires in the unit, etc, but the reality is that I have one red, one yellow, and one black wire in...
Bathroom fan/light: light works, fan doesn't
[ 3 Answers ]
I'm back with more "finishing basement" questions. This weekend, I wired my bathroom. This is 20 amp service with 12 ga wire. For the bath fan/light, the power source came into the switch box (1 box, 2 switches) on a 12/2 wire. From there, power goes up to the light/fan on a 12/3 wire. Red goes...
Bathroom Plumbing/Venting Question
[ 2 Answers ]
Hi, I am doing a bathroom remodel and moving the location of the fixtures to make more use of the limited space. The question is, will the room be vented properly based on the drawing I have submitted. I would really rather not have to run a new vent here. Thanks a lot for your help. View more questions Search
|