 |
|
|
 |
New Member
|
|
Dec 15, 2009, 08:49 PM
|
|
How much t.v. on power or off power
Do TV leave on that are cheaper on billing ? Or it is power off ?
|
|
 |
Pets Expert
|
|
Dec 15, 2009, 08:52 PM
|
|
What?
Are you asking if it's cheaper to leave the TV on or to turn it off?
TV's use electricity, you pay for electricity. The more you use, the more you pay.
In other words, leaving the TV on will cost you more then if you turn it off.
Why would you leave the TV on if you're not watching it?
|
|
 |
Uber Member
|
|
Dec 15, 2009, 09:30 PM
|
|
Energy star ratings limit the off consumption below about 4 watts. That's 0.004 KW, So in 250 hours, you'll use 1 KWH, typically $0.12 average cost is US
|
|
 |
Ultra Member
|
|
Dec 16, 2009, 06:44 AM
|
|
I think this comes from an old myth about a PC using less energy if it is left on, than turning it on and off repeatedly.
As everyone has stated above, turn your TV off. Turn off any electronics that are not being used.
If you have a full setup, like a home theater, there are "green" PowerCenters that you plug the TV or A/V receiver into one outlet, and if the device in that outlet is off, it cuts power to the rest of the units.
Example:
Monster Power - 8-Outlet Blackout PowerCenter Surge Protector - MP HDP 900G
|
|
 |
Uber Member
|
|
Dec 16, 2009, 10:10 AM
|
|
Devices that contain hard drives, don't need to be subjected to mechanical wear. Bumps, power fails, sags in the line voltage aren't good for them.
Each time the power goes off, the head lands on the platter. If it keeps spinning, it's riding on a cusion of air. 10 K RPM drives exhibit a lot of wear running.
So, in that light, PC's should stay on during lunch and turned off at the end of the day assuming a work day.
In the threat of a storm, they should be unplugged assuming no other protection.
The primary reason is the effect on the hard drives.
|
|
 |
Ultra Member
|
|
Dec 16, 2009, 01:05 PM
|
|
 Originally Posted by KeepItSimpleStupid
Devices that contain hard drives, don't need to be subjected to mechanical wear. Bumps, power fails, sags in the line voltage aren't good for them.
Each time the power goes off, the head lands on the platter. If it keeps spinning, it's riding on a cusion of air. 10 K RPM drives exhibit a lot of wear running.
So, in that light, PC's should stay on during lunch and turned off at the end of the day assuming a work day.
In the threat of a storm, they should be unplugged assuming no other protection.
The primary reason is the effect on the hard drives.
That's good to know. I had never heard any other reason to leave computers on. As far as the electrical noise, that's why I have a UPS and a line conditioner connected between my PC and the wall. Haha.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
2005 Chevy Tahoe Passenger Power Windows and Both Power Seats not Working
[ 3 Answers ]
I have a 2005 Chevy Tahoe. The passenger side windows stopped working and both passenger and driver power seats stopped working. All of this happened at the same time. I saw this same problem posted by another user back in January but I didn't see a clear answer. Does anybody know how to fix...
Car won't start, no click and no power to radio, power window or locks
[ 6 Answers ]
After installing a new starter on a 1999 2WD Explorer it will not start. There is no click when trying to start it, its just dead, and the radio, power locks/windows, a/c, and dash light don't work but the interior lights work and so do the headlights. We've had the starter checked to make sure...
Energy, power latent heat - data analysis - power storage systems
[ 33 Answers ]
1. One possible design for a storage power station is to use off-peak energy to compress air into a sealed underground canve and then, during periods of high demand, to reverse the system so that the air can drive a generator.
one system of this type compresses air from the atmospheric pressure...
92-92 civic no power to the fuel pump and no power or spark to the distributor
[ 9 Answers ]
Hello,
I have a 92-95 civic si. I am not getting any power to the fuel pump and no spark to the distributor. I have check all my sensors and have replaced the distributor. Checked the continuity to the distributor and all checks out good. I also have checked all grounds and all checked out all so....
View more questions
Search
|