Ask Experts Questions for FREE Help !
Ask
    rar91166's Avatar
    rar91166 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 14, 2009, 04:32 PM
    Furnace warp switch
    What does a warp switch do and is it located in gas valve? I recently replaced a gas valve and I think it had a warp switch that was bad. I had 24volts at the valve and occasionally the valve would not open to allow gas to the burner.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 14, 2009, 07:24 PM
    Exact brand of gas valve?
    Exact model number and all other information on the gas valve?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace won't light without a furnace switch reset [ 15 Answers ]

Hello I have a Tempstar/Keeprite furnace model HGF120NE-1, Serial number 8464124770. (the exterior of the furnace has Tempstar logo and interior of furnace has Keeprite logo.) This furnace has an intermittent pilot light system. At times, especially in the morning after allowing a...

Furnace relay switch [ 13 Answers ]

After duct cleaning my furnace (heat and air) does not work anymore. The thermostat indicates the system is on. Furnace light is on but the fan is not turning. There is that switch that you press when you open the door to the furnace. I guess is a relay swtich. On when door is closed and off when...

Fan only switch for furnace [ 5 Answers ]

Ok Guys, I found the thread about the switch for fan only by jumping the G to the R with a toggle switch. It worked. The fan comes on to circulate the air, at high speed. When the heat comes on it uses another speed which is a little slower. I know this because when I turn on my switch I get...

Furnace switch [ 3 Answers ]

I have an outside wood furnace. It has three wires in the fan switch. It will shock you when you touch the furnace itself. I can't find any breaks or bare spots in the wires. Any suggestions?

View more questions Search