 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Is this 1 or 2 elements? Usually supply goes through thermostat/thermal cuttoff then down to element. Look here: http://www.hotwater.com/lit/wiring/a7070.pdf |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Woke up this morning with no hot water. Went to check the water heater and found that some of the wiring in the water heater control panel (leading/near the thermostat) were burnt. I also noticed some blackened areas on the side of the water heater. So here is my question. Is is OK to replace...
I have an electric hot water heater. It was disconnected by some one that didn't label the wires. Coming out of the water there is a black, red and a screw for the ground. The wire coming from the wall has a white, red, black, and bare copper (ground). I need to know how to connect the wires. The...
I am replacing my hot water heater with one almost identical to the old one.The old one had a black and a red and a ground wire. The new one is the same. They are both 50 gal electric. The new one trips the breaker(basically it won't even let it engage). I assume my water heater is bad. It is a...
I have a 30 amp hot water heater I want to put a switch on it how do I conect the wires to th switch? Ron
How do I wire a hot water heater that is set up for 240 to 110? I don't want to have to put in a 220 plug I just want to run it off the 110 source already there. Any help would be great.
View more questions Search
|
