Ask Experts Questions for FREE Help !
Ask
    deme222's Avatar
    deme222 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 12, 2009, 06:07 PM
    Intertherm heaters
    I have an intertherm Propane Gas Furnace. We are on the coast, so we do not need the cooling unit. We seem to be experincing the furnace coming on, and then shutting off before it warms. Usually only running for a minute, then shuting off for a minute. Each time the furnace burner ignites. What could be the problem?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Dec 12, 2009, 07:29 PM

    Lots of possibilities. Start small & (hopefully don't) work your way up. Check/replace air filter if needed. Try this: turn off power, remove "R" & "W" wires from thermostat, and connect together. Turn power on and observe. If previous short/frequent cycling pattern continues, furnace is malfunctioning. If furnace sustains continuous operation, the thermostat is the culprit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm a/c not running [ 1 Answers ]

I have a intertherm (electric) funace and a/c unit model t3qc 36k(a/c). The problem is a clicking sound or eletrical pop sound for 5 minutes before it will start and sometimes it will not start at all.I have already called hvac tech and he said that it was my thermostat so I replaced the thermostat...

Intertherm [ 1 Answers ]

Where are the reset button located on the inertherm. I know there are 4 please help.

Water heaters vs. Tankless water heaters [ 1 Answers ]

Just curious about advantages of tankless over a traditional water heater.

Electric baseboard heaters -wiring 1 thermostat to two heaters [ 2 Answers ]

I would like to heat my new garage with electric baseboard heaters. The new garage is 20X24 feet. I would like to use only one 240V #12 2 wire circuit running two heaters at a total of 3800 watts. I plan to use 2 pole 20A breakers and 2c #12 wire. I would like to have both heaters controlled...

Intertherm furnace [ 1 Answers ]

I own a 1985 modular home and the intertherm blower fan on my furnace quit working is it too hard to fix or change?:confused: Also what is the cost to fix it?:eek: Please help!! :) Thank you Rachell

View more questions Search