My furnace will not start

chris58 Posts: 1, Reputation: 1

New Member

Dec 7, 2009, 02:02 PM

My furnace will not start

My furnace pilot works but the furnace will not cycle nor will the blowers blow

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Dec 7, 2009, 04:54 PM

Brand?
Exact model?

Add your answer here.

Check out some similar questions!

Furnace start up [ 4 Answers ]

I have a bryant furnace and when it calls for heat it will ignite stays on for a little bit Then it shuts down.any ideas that will help thanks model# 394gaz036100aafa Just wondering if it may be either flame sensor or spark ignitor.

Furnace will not start [ 4 Answers ]

I have an older model sears searies 600 model number 867761833 heater. The pilot light is on but the furnace will not start. The programmable thermastat is only a year old but I put new one in any way. I also changed out the thremocouple. A few weeks ago I noticed that it would start then stop a...

Furnace ignites but blower won't start till furnace shuts down. [ 7 Answers ]

(Nordyne/Miller G3RA)-I have a furnace HSI(glow plug) that will ignite and burn until it gets too hot and shuts down. As soon as the furnace shuts down the blower starts to circulate air. The blower circulating air cools the furnace and it reignites.Shortly after the furnace ignites the blower...

Gas furnace has an intermittent pilot, pilot lights, furnace tries to start [ 3 Answers ]

Have a 25 plus year old furnace pilot will start when signal sent furnace tries to start makes noise as it tries over and over but will not start. Thanks

Furnace can not start [ 3 Answers ]

I have a Frigidaire FG6RK072C-12 furnace for about 7 years. It started to have problems a couple days ago. The motor was running and then ignitor was on. But the burner might on for a short period and then cut off or it would start and cut off right away. I got a "pressure switch stuck closed"...