Ask Experts Questions for FREE Help !
Ask
    cragar77's Avatar
    cragar77 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 30, 2009, 02:39 PM
    Generac generator starting
    My Generac generator will start but will only run for about 5 seconds and then it stalls. It won't start when I try again. If I try starting it again, it will again run for about 5 seconds and stall. I've owned it for about 9 years and have NEVER had a problem starting this before. I ran it for at least a couple of hours last December to run it out of fuel. I then filled it with fuel again, added Stabil and ran it for a bit before putting it away. Any ideas?
    medic-dan's Avatar
    medic-dan Posts: 321, Reputation: 23
    Full Member
     
    #2

    Dec 1, 2009, 09:58 AM

    You don't specify the model so these are general:

    Do you have the low oil sensor? It may be cutting out the engine, how's the oil level?

    Do you have a fuel shut off valve under the tank? Is it wide open?

    If both of these check out then I suspect your carburetor needs cleaning. You can start by pulling the float bowl and making sure it is clean. Make sure the float is moving freely as well. Let some gas through the line to make sure it is not blocked.

    If that doesn't work the carb will need to be rebuilt. If you do this, note the position of every linkage on the carb - take pictures!

    I've had poor luck with Stabil over the past few years on my generators and snow blowers. I think it is just the new gas. Gave up and converted the generators to propane, the snowblowers get run once a month, even in July and August. No trouble since.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Generac 7550 EXL Generator - Motor Runs - no power [ 3 Answers ]

The unit quit putting power out motor runs I am getting 4-5 volts out of the receptacles I took the cover off the end unplugged the connector from the windings to the control panel and got 1.5 - 2.5 volts out of each lead (4 total) I checked for continuity between the leads and have it between...

Why I can pull the cord on my generac generator [ 4 Answers ]

I recently bough this used generator. It started a few times with no problem. This generator has an electric start that doesn't work. The other day I push the button and made a grinding noise. Today I try to start it but I can't pull the cord, it gets stuck. I remove the 4 screws that holds the...

Generac generator starting problems [ 1 Answers ]

My generator turns over constantly but won't start. What could be the problem?

Generator Help [ 14 Answers ]

OK, next question. I have bought a 6000 watt generator. It has four 110 outlets and one 220 "twist style" outlet. What I want to do is wire it into my house temporarily during winter power outages. I know already it will not run my entire house. We have two sets of gas logs, so heat is not an...


View more questions Search