Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Keeprite Furnace Problems
[ 2 Answers ]
I have an error 3 flashing dots which means"pressure switch open when should be closed" The unit is 13 months old. I can't get a tech out for 2 days everyone in my area is busy. Any help would be apprecaited.
Keeprite furnace maintenance
[ 1 Answers ]
I have a Keeprite furnace. There is a small plastic pipe 3/4 inch that runs from the furnace Into a 'cylinder' before going into the drain in the basement floor. The cylinder has now turned black inside. My questions are 1. What is this? Is it to do with condensation? ...
Keeprite products
[ 1 Answers ]
Does anyone have any thoughts on Keeprite furnaces and/or air conditioners.
KeepRite Furnace Reliability
[ 7 Answers ]
I'm in the market to replace my furnace with a high efficiency model, the contractor I'm talking with has recommended either a Goodman GMH95 or a KeepRite VS90, both are two stage. Does anyone have any comment on either, especially the KeepRite.
Gas furnace (KeepRite C8PN100F14B)
[ 1 Answers ]
I have a brand new gas furnace (KeepRite C8PN100F14B). It works well for a few days after it is installed. But after a few days the induced draft blower start immediately after heating run a heat cycle (even the thermostat now is satisfied). Then the induced draft blower keeps on and off very... View more questions Search
|