Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant Plus 80 gas furnace won't ignite burners
[ 6 Answers ]
I own a Bryant Plus 80 gas furnace. The fan will run if I set the thermostat to "Fan On" instead of "Fan Auto". But the burners will not ignite. I have followed the user manual instructions to re-start the furnace, but that didn't work. I have a gas water heater and it is heating so I know the gas...
Carrier gas furnace code 31
[ 3 Answers ]
Hi. I have a Carrier gas (propane) furnace 58MCA100-11116 series 111. It shows a code 31. The evacuation blower runs for a short time then kicks off. The burners do not ignite. To date I have: replaced the pressure switch, checked in and out lines to the pressure switch for obstruction,...
Gas Furnace won't Light
[ 1 Answers ]
I am trying to light my gas furnace in my house but it won't light. I light the pilot and when I turn the dial to on the flame goes away and no gas in going through! What am I forgetting or doing wrong?
Lenox Conservator furnace sparks but won't light
[ 2 Answers ]
Hi all I need some help. My furnace has been working fine until today. Today when it tried to fire up I could hear it sparking for almost 5 min and it never would light. It is a Lenox Conservator Natural Gas furnace the gas valve has 4 wires attached to it. I can see the plug and it is sparking...
Lenox furnace problem
[ 1 Answers ]
Have a 13 yr old Lenox furnace not staying lit continually. Lights for about 60 seconds kicks off for 2-3 minutes and back on again. Has a red light flashing. Anyone know what this could mean? Thanks View more questions Search
|