[Woodbob]

Hi,

I have a couple of questions concerning “Framing Nailers”
I own an inexpensive 21 degree framing hailer. I did not do
much research before buying. I was more concerned with cost.
I have used it to install a flat plywood floor in my attic, worked great.
Now I’m using it to install 2 X 4’s in my basement. I’ve put in a few
and I discovered that there is a problem getting the correct angle
for the nails. This could be me or the gun?
My question is, does the 21 degree’s meet my requirements?
I’ve seen some at 28 and 30 degree’s.
Also, what is the correct way of holding the gun to nail 2 X 4’s top and bottom at an angle through the 2 X 4’s?
I do have a problem getting it to fire at the correct angle, and they do not sink.
Thank you.

[hkstroud]

The angle of the nail gun is the angle of the nail strip and magazine relative to perpendicular. Has nothing to do with angle at which you shoot or drive the nail. If you nail gun does not sink the nails properly, increase the air pressure. The pressure requires needs to be adjusted to meet the needs of the length of the nail and hardness of the wood. The weight of the gun itself is also a factor. If your gun is light weight (physical) you may need to hold it down with your other hand when you shoot. The weight of the older style, heavier guns is an advantage.

[Woodbob]

Hi,

Thanks for the info.

This makes me ask "Then why all the different angled guns"?

Nailing 2 X 4's on 16" centers what angle gun to use?

[hkstroud]

Why?

A. Just to be different.
B. To make you buy their nails.
C. Some people prefer the way one feels over the other. Some people say you can get into a corner better with one over the other.

There is even nail guns that use a coiled magazine. More compact.

They all shoot nails. Practice, practice.

[Woodbob]

Hi,

Thanks for the info.. I'll stick with mine and practice some more.