Ask Experts Questions for FREE Help !
Ask
    stuckonthehill's Avatar
    stuckonthehill Posts: 2, Reputation: 2
    New Member
    		  
    #1

    Nov 13, 2009, 05:08 AM
    Trane XL90 won't heat -- 5 led flashes
    I hava a Trane XL90 furnace that was installed new about 3 years ago (oct 2006). Yesterday it stopped heating; and only blows unheated air out the registers. The Control board Red LED flashes a code 5. The Green LED is flashing slowly. The local HVAC company looked at it and concluded that the Control board was bad. It's kind of expensive to replace the Control board and so is there a way to confirm that is the problem?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 13, 2009, 07:55 AM

    The info for the codes should be on the back of the door or on the control itslef. Also in you owners manual. The furnace has a 5 yr warranty so the board should not cost a thing.
    stuckonthehill's Avatar
    stuckonthehill Posts: 2, Reputation: 2
    New Member
    		  
    #3

    Nov 13, 2009, 08:49 AM

    Thanks for the info -- I didn't know the codes were there and my HVAC guy was less than clear on the warranty question.

    I believe the problem has been solved. I cleaned/remade all the ground connections because I heard this furnace (Trane XL90) is very sensitive to any faulty ground connections. The unit now fires up properly -- No more fault codes. Cycled repeatedly and works every time, but I'll keep an eye on it for a few days.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where is the limit switch on a trane XL90? [ 2 Answers ]

Had a Trane XL90 two-stage high efficiency gas furnace installed in 02'. Open limit switch diagnostic L.E.D. came on last night and the electrical schematic is completely corroded need help finding the switches. Thermostat said 43 this morning.

TRANE XL90 frustrations [ 12 Answers ]

I need some advice and help. I have a Trane XL90 (#TDC1008948A0). It runs fine sometimes and then every now and then switches off and starts to blick orange on the led for about 1-2 seconds before trying to go green again. Sometimes it will eventually go green and light again but other times...

Trane xl90 gas furnace red light [ 1 Answers ]

I have trane xl90 gas upflow furnace red light blinking on circuit board no legend any where anybody know where to get information

Trane XL90 Pressure Switch Error [ 1 Answers ]

I tried to start up my furnace this weekend and I got 1 click and then a 2nd click and the error code for pressure switch. I need to know what my next step is to disgnose the problem and get it running since the temps are dropping to just above freezing at night now. I had the blower motor...

Trane xl90 [ 1 Answers ]

I went to start my furnace and my furnace was blinking 19 green and one red can someone please help me there is nouthing happing no blower no nouthing but flashing lights

View more questions Search