Ask Experts Questions for FREE Help !
Ask
    kidcross0681's Avatar
    kidcross0681 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 6, 2009, 04:52 AM
    Bryant furnace roll out switch trips on low
    I have a bryant 80,000 BTU 90 plus two stage furnace Converted to propane. The problem is when it is in the low heat cycle the roll out switch trips. But on high it does not. I currently have the furnace in the emergency run mode. I have already cleaned the combustion air and exhaust vents. The burners seem to have a white flame on low. I was thinking it was a gas valve pressure problem but I cannot find gas pressure spec for the low stage anywhere. If you could find the spec or have any other ideas what it may be I would appreciate it thanks. John
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Nov 6, 2009, 04:56 AM
    Exact model number
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #3

    Nov 6, 2009, 09:59 AM
    If a proper propane conversion was performed, there should be a label placed over the natural gas values on the rating sticker.
    kidcross0681's Avatar
    kidcross0681 Posts: 2, Reputation: 1
    New Member
     
    #4

    Nov 11, 2009, 05:12 PM
    Found the correct gas pressure and adjusted it but roll out switch still trips. Model number 355mav042080.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #5

    Nov 11, 2009, 05:22 PM
    This suggests a problem with the heat exchanger. I would suspect restriction of the secondary H/X or the cold-spot baffle. Your version of the circuit board may have a DIP switch to lock the unit into high-fire mode until it can be checked by a pro. Look at the schematic label for list of "SW - * - *" selections.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Switch/Circuit board switch trips with Dehumidifier in basement [ 1 Answers ]

Hi, I have whirlpool gold dehumidifier of 40 pint, running in basement for last 4 years, all of sudden it stopped working, when I checked it tripped the circuit board switch. I tried re-setting switch and plugged in the dehumidifier, it runs for 3 seconds and again switch trips. I tried in...

Furnace roll out switch [ 1 Answers ]

Can't seem to discover why the roll out switch above the top burner trips after about an hour of heater operation. Unitary Products horizontal propane furnace. Filters are clean, vent is clear. Cabinet near burners not excessively warm. The controller blinks 5 times until the switch is reset. ...

Roll out switch [ 1 Answers ]

What can cause a roll out switch to open on a warm air gas furnace

Roll out switch trouble [ 1 Answers ]

What can cause a roll out, the switch keeps tripping? The roll out can be seen but the exhaust blower is working. The heat exchanger is not cracked, I had it checked by the local gas company.

Bryant 394GAD Vent Safety Switch Trips [ 1 Answers ]

I have a Bryant 394GAD that runs fine for days, then begins to have issues with the Vent Shut Safety Switch tripping and shutting down the flame. The fan continues to run and blow cold air throughout the house. If I reset the switch, the burners will come back on and the furnace will run. ...


View more questions Search