Ask Experts Questions for FREE Help !
Ask
    nicolled's Avatar
    nicolled Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 10, 2009, 06:02 PM
    Clicking sound before burners ignite
    After my pilot lights on my Lennox WhisperHeat furnace, shortly after there is a clicking sound (sounds like a switch) immediately before my burner ignites, however instead of clicking once as it used to, it is now clicking about 4 or 5 times before the burners ignite. Can someone tell me what this is? Thanks!
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Nov 10, 2009, 06:09 PM
    Try to determine if the "clicking" is coming from the ignition module or the gas control. Both will be visible with upper front panel removed.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rhemm Burners won't ignite! [ 5 Answers ]

Hello, I have a Rheem Criterion II about 15 years old. Down Draft Furnace I just replaced the blower motor and it works great. The problem is when I fire up the furnace the blower comes on the ignite r glows and than just when the burners should ignite the system stops? The green lights on the...

Burners will not ignite [ 1 Answers ]

I have a Day/Night forced air heater and the burners will not light. The fan runs but the igniter glow device does not turn red and the gas valve does not open. I have run the on test mode and the igniter glows red but when turned on by the thermostat the igniter does not work. I have checked the...

Gas furnace burners won't ignite [ 4 Answers ]

17 year old gas furnace... burners won't ignite. What are the logical troubleshooting steps to solve this problem?

John Deere L110 Clicking sound on start - new solenoid, still clicking! [ 1 Answers ]

Hi all, I cut my lawn, engine was running for about 2 hours. Stopped at neighbors house, cold beer, go to restart, just a clicking sound. Thought battery was dead, did a quick check, good voltage, hooked it up to a charger, good amps. Still clicking. I figure it's the solenoid, picked one up...

Burners won't ignite--no gas? [ 1 Answers ]

Lennox model GMP075-3. Installed in '95. I've tried resetting according to instructions on access cover panel (turn heat to 'off', turn off power to furnace, turn gas valve to 'off' for 5 minutes, etc.) When I call for heat, small (induction?) fan runs for a few seconds, the igniter unit glows...

View more questions Search