Ask Experts Questions for FREE Help !
Ask
    redman517's Avatar
    redman517 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 25, 2009, 12:41 PM
    Bryant gas furnace Model#383KAV doesn't light.
    I've got a Bryant upflow gas furnace Model #383KAV that quit working last night. I just put a new blower motor inducer motor and a ignighter in and it was working fine. Now when I try to light it all that happens is the blower motor comes on for about 1 minute then it just stops. Normally the inducer motor and the glow stick and then lighting and then the blower motor. The red light will flash 3 quick flashes and 1 long flash. Please help it's cold in here. Thank you.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 26, 2009, 04:57 AM
    If code 31

    PRESSURE, DRAFT SAFEGUARD, AUXILIARY LIMIT (when used), OR BLOCKED VENT SHUTOFF (when used)SWITCH DID NOT CLOSE OR REOPENED. Then check for:
    -Proper vent sizing and condensate pitch or sag
    -Vent restriction or high winds
    -Defective inducer motor or start capacitor
    -Defective pressure switch or connections.If it opens after trial for ignition period blower will come on for 90 second recycle delay
    -Inadequate combustion air supply
    -Low inducer voltage
    -Disconnected or obstructed pressure tubing


    This next item is just for your future info. It is about the mounting procedure for your ignitor. While this is probably not your problem right now it could be a problem in the future.

    http://www.xpedio.carrier.com/idc/gr...ik332505-1.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Furnace model 383KAV won't kick on [ 10 Answers ]

I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...

Bryant model#310AAV042090ACJA Gas furnace LED light off [ 5 Answers ]

Hi, I have a Bryant model#310AAV042090ACJA Gas furnace. The system just won't turn on. I checked and the LED light is completely off. Turned power off to system, gas off, waited couple minutes, turned back on; nothing - won't turn back on. Strange thing is that at night it did not work, then in...

Bryant Model 330aav furnace Problems [ 8 Answers ]

Hi My furnace stopped working this morning. It's 8 degrees here in Michigan... brrrrr. :( I checked for an error code but the LED light was on continuous. The problem was that the furnace was on (flames going) but the fan would only stay on for about 2 minutes and then turn off. I had...

Bryant furnace Model 100-394U won't Light Up [ 2 Answers ]

My bryant furnace model 100-394u won't light up.the gas is on,the pilot is on but it still won't light. Last year I put a new hunter thermostat and it worked all winter but this year it won't start any advise

View more questions Search