Ask Experts Questions for FREE Help !
Ask
    juls237's Avatar
    juls237 Posts: 2, Reputation: 1
    New Member
     
    #1

    Oct 17, 2009, 07:31 PM
    Odd flush of toilet
    Just moved into new house. Have 3 toilets, all same. 2 flush just fine. One in master bath I have to hold the handle down to fully flush it, and while doing so it flushes twice. What could cause this?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Oct 18, 2009, 04:51 AM
    I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Your toilet flushes twice because of the extra water that's being delivered by emptying the tank. Hope this helps and thank you for rating my reply.. Tom
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
     
    #3

    Oct 19, 2009, 07:41 PM
    Quote Originally Posted by juls237 View Post
    Just moved into new house. Have 3 toilets, all same. 2 flush just fine. One in master bath I have to hold the handle down to fully flush it, and while doing so it flushes twice. What could cause this?
    If you are having to hold the handle down to make the commode flush it could be because the handle is not lifting the flush ball or flapper as high as it needs to be and the suction of the water going out of the tank is pulling the tank ball or flapper back over the hole in the flush valve.

    If you have a flapper with a chain that lifts the flapper try shortening the chain just a little. If you have a flush ball that is connected to the handle with two lift wires then try bending the handle arm up just a little.

    If this is not what you problem is then never mind my suggestions.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet Flushing: tank drains, toilet doesn't flush, brand new toilet. [ 4 Answers ]

I read the other postings, and most of the problems came in with old toilets. Mine is brand new (within a year old) and I just moved in to my new place. The condo has 2 identical toilets and the other flushes just fine. I have mimicked the settings of the working toilet and still can't get my...

Flush toilet upstairs overflow in toilet downstairs [ 3 Answers ]

We have a toilet in the basement which has never been used in our five years in the home. Yesterday, there was toilet water everywhere. When I flush upstairs, the water in the downstairs toilet rushes up. Is this related to a blocked stack pipe? Just guessing.

First Flush of Toilet does NOT work right BUT second flush works great? [ 4 Answers ]

We have 2 toilets and both have the same problem. The first flush does NOT work right and will NOT flush completely, water rises and then goes back down. The second flash works GREAT? We have plunged and clean out all blow or jet holes NOthiNG is plugged? Short of double water bills and the...

Toilet will not flush [ 2 Answers ]

Our toilet bowl will not flush. Water from the tank runs into the bowl however the bowl will not finish the flushing process. Also, air bubbles up into the bowl and shower.By using a plunger we get rid of the water in the bowl. Any assistance would be appreciated as we are beside ourselves on...

Toilet tank lever breaks when I try to flush toilet [ 1 Answers ]

I have a problem trying to flush my toilet. When attempting to flush the plastic tank lever often breaks and when I use the metal tank level they often bend. The only way to flush the toilet is by removing the top and pulling up the tank ball lift by hand. What can I do to solve this problem. Thank...


View more questions Search