Ask Experts Questions for FREE Help !
Ask
    donnarose's Avatar
    donnarose Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 17, 2009, 04:43 AM
    Furnace won't run.
    My furnace won't run unless I go down and lift door and put it back on again. After doing this it will lite and run for one cycle and that is it, I have had it cleaned, and was told it was fixed, but still doing the same thing. I think it has something to do with the door switch. Any help please. It's getting cold. I can also reset my thermostat and it still won't start.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 17, 2009, 08:45 AM
    Try replacing the door switch or adjusting it if possible. I feel you are on the right track.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Add on coal/wood furnace thermostat wiring for 2 zone house with oil furnace [ 1 Answers ]

I purchased a Harman wood / coal furnace model SF-2500 (forced hot air system) and am tying into my existing forced hot air oil furnace 2 zone system and do not know how to tie into the existing thermostats and zones. I wish to still use the 2 separate zones for the bedrooms and the main body of...

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search