 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Blower and thermostat function, heater not functioning
My furnace won't kick on. But the ac works and the green light on the furnace indicates it is operating properly. I took off the thermostat and shorted the red and white wires and got no response. But if I set it to fan only the blower comes on.
It is a Lennox model number - G14Q3-60-12 |
||||
Check out some similar questions!
Hello to everyone using the site, Current setup is a coleman electric furnace and there is a carrier unit outside the home for a/c. I am in a mobile home built 1995 sized about 1780 sqft, living in Florida where the temp gets over 90 most days right now. Problem I am having is that I do not...
I just purchased another home and everything some day will be replaced for the pool. I've had it serviced recently. As far as the heater is concerned, the technician took off the heater's actuator so I could manually use it. But now the heating unit isn't turning on. There's a panel inside...
I recently "upgraded" to a digital thermostat so I could program heat cycles while out of the house. The HVAC unit is an Intertherm sealed cumbustible furnace model number MGHA-056ABFC-01 that runs on propane. The entire unit sits in the house and it has two wires going to the thermostat (red and...
My heater is set at 72 but the house is 58. My heater turns on for about 1 - 2 minutes and shuts off for 1 -2 minutes. This process is repeated until the desired temperature is reached. What could possibly be wrong?
I recently changed from a manual-digital thermostat to a Lux TX9000TS electronic thermostat. All functions (Air, Heat & Fan) worked with the old thermostat. With the TX9000TS the air works fine and the fan blows in fan only mode. In the heat mode the Gibson air handler in the basement clicks and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
