[tommytman]

I'm thinking of replacing an old tub (american standard recessed tub) with a new claw foot tub. The only part I think I may have trouble with is connecting the drain. I don't think the drain line in the floor will be where it needs to be for the new tub. I am on a slab and wonder how they set up the drain lines... and how easy it would be to move it a few inches.

[tommytman]

Should have also said:

The drain lines are all cast iron and connect either by pipe thread or by rubber gromet-like inserts in the bell portion of the cast iron pipe.

[speedball1]

I'm thinking of replacing an old tub (american standard recessed tub) with a new claw foot tub. The only part I think I may have trouble with is connecting the drain. I don't think the drain line in the floor will be where it needs to be for the new tub. I am on a slab and wonder how they set up the drain lines....and how easy it would be to move it a few inches. The drain lines are all cast iron and connect either by pipe thread or by rubber gromet-like inserts in the bell portion of the cast iron pipe

A Typical tub rough-in is 1 5/8" in from the floor plate behind the drain and 15 1/2" out from the wall. What's the rough-in specs on your claw foot tub?

We use several methods to join cast iron pipe. None of which include pipe threads, (unless we're converting to another type of pipe from cast iron.) The three most widely used are, lead and okum joints, Neoprene inserts,(rubbers) and No-Hub bands. Regards and thanks for your input on this site, it's appreciated! Tom

[tommytman]

Speedball,

Here is an example of what one of the tubs looks like

http://www.clawfootclassics.com/sotcntmspec.asp

From what I can tell (from the above link) if the rough in is 1 5/8" in from the floor plate behind the drain and 15 1/2 out from the wall then I will be fine. Problem is when I try to measure including tile thickness (in the existing bath) I'm getting something like around 13 1/2 inches and not 15 /12. But without looking under the existing tub it is hard to say what I've got there.

What kind of connection exists under the tub where the overflow and tub drain come together and run into the stub out?

[speedball1]

Speedball,

Here is an example of what one of the tubs looks like

http://www.clawfootclassics.com/sotcntmspec.asp

From what I can tell (from the above link) if the rough in is 1 5/8" in from the floor plate behind the drain and 15 1/2 out from the wall then I will be fine. Problem is when I try to measure including tile thickness (in the existing bath) I'm getting something like around 13 1/2 inches and not 15 /12. But without looking under the existing tub it is hard to say what I've got there.

What kind of connection exists under the tub where the overflow and tub drain come together and run into the the stub out?

Tommy, Go to http://www.clawfootclassics.com/ltdraintips.asp to see the drain specs. On your claw foot tub.
The site does not give rough in dimensions but when I have more time I'll see what I can come up with. Tom

[laurenhastie]

We have a drain set for a original clawfoot tub, but I would like a double ended tube. Is there an easy solution to the drain issue, or will we need to have the concrete busted out to move the drain

[speedball1]

Is there an easy solution to the drain issue, or will we need to have the concrete busted out to move the drain

Give me the measures of the trap raiser from the front and side wall and I'll tell you. Cheers, Tom