Ask Experts Questions for FREE Help !
Ask
    DIYPHOTO's Avatar
    DIYPHOTO Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 28, 2009, 03:48 PM
    Through the wall ducts for OTR microwave
    I'm trying to find the venting parts (ductwork) for our OTR microwave. I want to vent it through the wall so it would be a very short piece of duct (8" maybe) plus the wall cap for the exterior. The duct opening needs to be 3.25" x 10" to fit the microwave opening. The instructions have a dandy little illistration of one but fails to tell you where to get it.

    I have tried Lowe's, Home Depot, Ace and a HVAC & plumbing supply house. Can't find it on the internet, either.

    If anyone can help, I'd really appreciate it.

    Thanks.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Sep 28, 2009, 04:28 PM

    Looking for that?: Browsing OVAL
    DIYPHOTO's Avatar
    DIYPHOTO Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Sep 29, 2009, 07:47 AM
    Thanks for the reply, but I don't think that would work. I need the 3.25 x 10 rectangle. I don't get what the comparison is all about at that site.

    But looking through their site, I think I found what I needed http://www.audubonsupply.com/browse.cfm/4,6704.html

    Thanks again.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Odor from air ducts after ducts were cleaned [ 7 Answers ]

I had my air ducts cleaned a year ago (big big mistake) and immediately had a sickening odor. Had them re-cleaned and sanitized and still bad odor. Had evaporator coil cleaned and again 6 months later. Then had UV light installed. Now I have a chlorine odor that permeates everything in the...

Ducts too big? [ 2 Answers ]

I am setting up some HVAC Zones in my home. I bought the motorized dampers and the bypass dampers. I did not take a scientific approach and just guessed at the size of the ducts/dampers based on what was there. That is if the "zone" had one sized, I added a "feeder" duct 2-3 inches bigger. Now I am...

Heating Ducts [ 1 Answers ]

Can heating ducts be changed to something less intrusive? My ductwork was install to work with an old gravity-heater. I now have a new heater with an electric blower system. I want heating ducts that are less intrusive in the room.

Magic Chef gas wall oven/microwave [ 1 Answers ]

Where can I find part #y02060372 control which is discontinued

View more questions Search