Ask Experts Questions for FREE Help !
Ask
    crwamsley's Avatar
    crwamsley Posts: 5, Reputation: 1
    New Member
     
    #1

    Sep 26, 2009, 06:25 AM
    Bryant 90 Plus burning smell no blower
    My inside fan isn't running but the unit runs on the outside of the house.

    In this thread KC13 recommended putting the heat or cool wire on the PRI-1 connector.
    https://www.askmehelpdesk.com/heatin...-327491-2.html

    I did that and the fan didn't run. So I'm assuming that's the problem.

    My model # is 350mav036060fgka.

    What part(s) exactly do I need?
    crwamsley's Avatar
    crwamsley Posts: 5, Reputation: 1
    New Member
     
    #2

    Sep 28, 2009, 02:02 PM
    Anyone? Is my troubleshooting correct? Is it the fan?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #3

    Sep 28, 2009, 03:11 PM

    Check for power to fan, if it is receiving 120v, and not turning, check the capacitor, if cap is good, then yes, sounds like a bad motor.
    crwamsley's Avatar
    crwamsley Posts: 5, Reputation: 1
    New Member
     
    #4

    Sep 30, 2009, 05:49 PM

    I realized I had done the self test shorting the com24 and test terminals. Did that and the fan kicked on.

    So maybe the capacitor. Where is it? How do I test it?
    crwamsley's Avatar
    crwamsley Posts: 5, Reputation: 1
    New Member
     
    #5

    Sep 30, 2009, 07:36 PM

    Found the capacitor and removed it.
    crwamsley's Avatar
    crwamsley Posts: 5, Reputation: 1
    New Member
     
    #6

    Oct 1, 2009, 03:45 PM
    It was the cap. Thanks!
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #7

    Oct 1, 2009, 04:00 PM

    Glad you got it fixed. Take care.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 90 Plus furnace burning smell, no blower [ 18 Answers ]

Hello everyone! I moved into this house around 3 years ago and this furnace was already here. We have had no problems with this furnace until now. Last night the furnace, (pre-blower) please correct me, kicked on and the burner lit good but the bottom blower motor would not turn on. The red...

Burning Up 24V Transformers on a newer Bryant Oil Furnace [ 4 Answers ]

We have a 3 year old Bryant Oil Furnace, Model 369AAN series "C", that recently started burning up the 120/24 volt coil. The 120/24V coil powers the thermostat. We've burned up two coils within the past two days and am getting ready to repace it for the third time.

Bryant blower [ 1 Answers ]

My Bryant furnace and air conditioner does not work, turn the blower on manual and the blower does not rotate but, hear the motor humming. Does this mena the motor is burned out? Should I replace the motor and how involving is the procedure?

No blower on Bryant mdl plus 80t [ 5 Answers ]

I have a 2 year old Bryant Plus 80 t unit the blower will not kick in after the burner lights up, I've checked the fuse on control panel , not blown, a small led light on control panel blinks on and off. Stat is digital and working, burners have bright blue flame and shut down after a minute or...

Bryant plus 90 furnace Smells like elecrical burning. [ 2 Answers ]

Hello, I hope someone can answer my question. I have a Bryant furnace Plus 90 model and I started smelling like electrical burning through one of the air ducts that goes to the upstairs of my home. It is hot right above the access panel. Could someone tell me what this could be. I can only smell...


View more questions Search