Ask Experts Questions for FREE Help !
Ask
    Oneill474's Avatar
    Oneill474 Posts: 427, Reputation: 2
    Full Member
    		  
    #1

    Sep 20, 2009, 11:48 AM
    Pump wiring 1/2HP 120volts northern tool
    Instructions state prepare a three core electrical set with plug. Okay
    Loosen the two copper screws marked with "V1 W1 & U1 and fasten the electric
    Power leads to them.

    But which one is hot(Black) and which one is Neutral(white) or does it matter.
    I know where the terminal for the green ground wire goes. 110 volt motor.

    There is another terminal they do not mention it the instructions v2-U2
    Sit away from the rest? Must be for something else?
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #2

    Sep 20, 2009, 12:24 PM
    Sounds like it's a 220 volt motor. Which motor is it?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Sep 20, 2009, 12:42 PM

    Is this the pump you have?

    Instructions apparently written in another language and translated to English.
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pump Wiring [ 2 Answers ]

How do you wire a Pentair 110V/220V 1HP pump to 110V? The diagram indicates connecting to BROWN at the top and L2. There is a brown wire on the bottom but no screw to connect to. The top wire is WHITE but again no screw to connect to. There are only two screws to connect to and they are labeled...

Wiring a water pump [ 5 Answers ]

The manufacture just told me: The item is pre-wired at 120 volts And you can re-wire it for 230 volts the manual will have instructions to re-wire for the 230 volts My apologies.. this can Not be wired for 220 My breaker panel has a 50amp breaker for the pump. I guess it A 220 line. ...

Underground wiring - well pump [ 1 Answers ]

Hi I am trying to run this AWG 6-2CU UF-B underground feeder cable from the basement to an outdoor well pump controller. This is a three wire (two isolated + ground) cable that is to be connected at 240Vac from the main panel and routed out for about 200ft. The controller is supposed to limit...

Monitoring Ad Click Tool and Autoresponder tool [ 1 Answers ]

Hi, I want the details of the AD Click Tools and Autoresponder tools. Regards, Stany

Yo Northern [ 2 Answers ]

I did my best while you weren't here, but let these go: https://www.askmehelpdesk.com/heating-air-conditioning/replacing-15-yr-old-carrier-heat-pump-best-suggestion-52021.html https://www.askmehelpdesk.com/heating-air-conditioning/continual-boiler-pressure-drop-51694.html ...

View more questions Search