Ask Experts Questions for FREE Help !
Ask
    pbr3232's Avatar
    pbr3232 Posts: 38, Reputation: 2
    Junior Member
     
    #1

    Sep 2, 2009, 10:35 AM
    Snaking a cable driven tub drain
    I was wondering how you take apart and snake a cable operated tub drain.

    Thank You
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
     
    #2

    Sep 2, 2009, 10:43 AM

    Remove the overflow plate and snake it from the overflow, see the images, good luck.

    John
    Attached Images
      
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Sep 2, 2009, 11:00 AM
    Quote Originally Posted by pbr3232 View Post
    I was wondering how you take apart and snake a cable operated tub drain.

    Thank You
    John gave you good advice. Let me flesh it out a bit. Unscrew and remove the overflow plate,(The one with the drain lever) and pull out the tub stopper. (see image) You now have a clear shot at the trap. Now feed the cable( 1/4" best or 3/8ths" with a small auger tip. A hand snake will do it, (see image) About 2' down you will run into the bend of the trap. Crank and push at the same time to work around it. Your blockage will be found in the lateral pipe going to the stack. You shouldn't have to put out more then 10 or 12 feet. I have found tub and shower clogs to be mostly hair and the worm should auger into it and pull it back. After flush with a half of tub full of hot water. Hope this helps and thank you for rating my reply. TOM

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Snaking out a floor drain [ 4 Answers ]

My wife and I recently (less than three months) bought a one story slab\cinder block foundation house. At least I describe it that way since the utility room is on a lower level than the rest of the house. It was owned by a single gentleman for I think roughly 20 years before us. A little more...

Drain not draining, snaking no difference [ 1 Answers ]

I have a double sind in the kitchen that takes at least 3 hours to drain. It is ithe only fixture at that end of the house. I ran a 50 foot snake just under the drain, the house is 35 feet long. The other fixtures all drain fine except the dish washer which is next to the sink. I replaced the...

Need 3" floor depth adjustable cable drain. [ 1 Answers ]

Installing custom shower, need to install cable drain overflow to go through 1 1/2 lite weight concrete, 3/4 plywood, tile and tub liner (membrane). Aprox 3 inch. Who would manufacture this adjustable drain?

Drain snaking: how to tell if drain is clear? [ 4 Answers ]

Hi there! In a previous post, I discovered that one of the two main 4" cast iron drain lines from my house (goes to septic) had standing water in it: https://www.askmehelpdesk.com/plumbing/cracked-cast-iron-pipe-107834.html Even though I've never had trouble with this drain, it seems like...

Drain machine cable stuck [ 2 Answers ]

Hi, I am a do it yourselfer, who should sometimes let someone else do it. Anyway I had a clogged drain line, was a main coming out of the house to my septic tank, 3 inch in the basement going through the floor. I borrowed an auger machine from a friend with a 80 foot 3/8 cable. After running a...


View more questions Search