Ask Experts Questions for FREE Help !
Ask
    jzitawi's Avatar
    jzitawi Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 4, 2006, 07:35 PM
    How To locate the pressure reducing valve
    I need to replace my pressure redcing valve to eliminate the noizy water in the house but I am not able to find where its located
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Nov 5, 2006, 08:35 AM
    A pressure reducing valve is installed just after the service enters the house.
    Regards, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure relief valve [ 11 Answers ]

Hi, I have a State Select brand water heater (40 gallon) which is about 4-5 years old. It recently has begun to leak from the pressure relief valve, and is leaking a lot:( , especially after taking a shower... Is this a simple fix of replacing the valve or something more serious? Any and all...

Failed HomeWater Pressure Reducing Valve [ 1 Answers ]

I think that the PRV for my home water supply is not working properly. I have the pressure adjustment set to the lowest pressure (range 75 to 25). I have loosened the adjustment bolt all the way until I can turn it with my fingers. When I check the pressure at washer supply line both hot and...

Gas valve pressure problem [ 1 Answers ]

I had an old Coleman Evcon furnace, the problem is when the flame came out doesn't come strong because the fleame stay right at the nozzle of valve pipe,

Pressure reducing valve? [ 3 Answers ]

Hi again, Firstly, thanks for all your advice so far... I installed the thermostatic shower valve (by hudson reed of the UK) and shower arm (using drop eared elbow as per your advice - thanks!). I checked for leaks and there were none, but when I turn the volume of water up to try and get...

Installing a pressure balancing valve [ 1 Answers ]

I have a question regarding the installation of a 35.253.000 Grohsafe-enhanced flow pressure balancing valve. What it the recommended way of installing the valve to the 1/2" copper supply pipes? The shut off valves on the sides are 1/2-14NPT male X 1/2" copper sweat. Should I use brass drop ears on...

View more questions Search