Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Heat and Cooling Ducts into New Addition
[ 1 Answers ]
I am adding a new 12'x24' addition onto the back of my 24'x24' 2-story home(90 years old). The floor joists will run the same direction. Each existing vent is fed by it's own 6" pipe from the furnace. What is the best way to heat and cool this new addition? Can I or should I cut round 6" holes...
How do I use existing ducts to heat/cool the bassement?
[ 1 Answers ]
I just finished my basement and I want to use current HVAC ducts in the basemet for airconditioning. I have central air and I have some idea as to how I can accomplish that but I have never done this and would appreciate expert technical advice - right from tapping into the source to connecting it...
Galvanized heat pipes
[ 3 Answers ]
I have a 1950's ranch with galvanized supply and return lines that connect to copper baseboard radiators. It appears they are using a brass or copper fitting that is soldered to the copper below flore level. There are plugs on the bottom of all these fittings. The strange part is that the...
Loud banging heat pipes
[ 1 Answers ]
Hello - Maybe someone out there can shed some light on my problem. I recently had heat installed in my basement. It runs across the basement ceiling (above drywall) and behind sheetrock walls between studs. When the heat turns on you can hear a trickling of the water running through the pipes,... View more questions Search
|