 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
There's a small tube that runs from your pump to the control box. Disconnect it and see if pressure co9mes out. Check it to be sure it's not clogged. Open up the control box when the pump's up to pressure and turn on a hose bib to bleed the system down. Tell me at what PSI the contacts energize and start the pump. If the small tube's clear you might consider replacing the control box. Good luck, tom
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Lennox Complete Heat HM30 hot water tank. Dig 2 is flashing which indicates a problem with the preasure switch. What can I do?
Were can I get a diaphram for a Square D pressure switch I live in the Greenbelt area of Maryland (20770)
When my square d water pressure switch hits the low setting, about 30 psi, the water pressure drops to almost nothing for a second or two before the submersible pump kicks in. Is this a switch problem. It holds pressure fine when the pump stopps pumping as long as it stays above 30 psi. Thank...
I have a well water system in my house however in the last couple of weeks I have been losing water pressure. Especially if I have more than one source pulling from the pump. I have a Pump and reservoir in the basement the pump fills the tank and I us what is in the tank it only about 5 gallons...
View more questions Search
|
